FNX940

A frame for FNX-9 and FNX-40 part kits

by nguyenkvvn minor geometry referenced from the FNS940 model by TMS

Description

The FNX is a polymer hammer-fired pistol availible in 9mm and .40 S&W. It is a precursor to the FNS series of pistols. It uses plates for rails, rather than a monolithic locking block or integrated into the fire-control housings. It is only availible commercially in full-size configuration.

Geometry that was referenced from the FNS940 model by TMS includes but is not limited to: magazine button cut-out, magazine button spring relief, trigger pin location.

Materials Required

You will need a set of each below for each FNX-9/40 you make.

This model is compatible with any FNX-9 or FNX-40 parts kit. It is not compatible with the FNX-45 or FNX-45 Tactical.

• x1 Parts Kit - Procure a parts kit of your preferred caliber.
• x1 Magazine - Procure a magazine of your preferred caliber

Instructions

• Print with PLA+, or Tough PLA.
• Tree supports are recommended
• Print rails down on the bed
• It is imperative your printer has no elephant footing- otherwise the rail plates may not seat properly!

Assembly instructions can be found in the rich-text PDF included.

Change Log

• v1.0: Release

  • Promotion to release

• v0.4: Private Beta Candiate 4

  • Revised front takedown lever clearances
  • Omitted horseshoe geometry
  • Refined front rail fitment geometry

• v0.3: Private Beta Candiate 3

  • Loosened tolerances for rear rail plates
  • Loosened tolerances for front rail / locking block places

• v0.2: Private Beta Candiate 2

  • Added right-hand safety selector cutout
  • Re-introduced some takedown-lever geometry
  • Tightened tolerances for the front locking block plates

• v0.1: Private Beta Candidate 1

  • Initial commit

License

No license selected