The M&P

Smith & Wesson M&P 1.0/2.0 Frame

by Wunder9

Description

The Smith & Wesson M&P 1.0/2.0 Frame by Wunder 9

Materials Required

You will need a set of each below for each [x] you make.

• x1 M&P9 or M&P40 1.0 or 2.0 - Procure a parts kit of your preference.

Instructions

Suggested print settings: Material: PLA+ (Recommended) Layer height: 0.2mm or smaller (Recommended) Infill: 99-100% (Use best judgement) Walls: 4-10 (Use best judgement) Support: Everywhere

Change Log

BETA v0.03 -Grip extension forward face made flush with rear of magazine well (for smoother magazine insertion) -First release to include f3d CAD file BETA v0.02 -Trigger pin hole diameter changed from 0.125 in to 0.15 in (fix trigger pin fit) -2.0 sear block notch geometry revised (non-mandatory, done to better align hole with locking block protrusion) -Slight adjustments to rear rail clearances (non-mandatory, adjusted tolarences to better fit 2.0 rear rails) -Magazine release angle changed from 18 degrees to 23 degrees (shifts magazine 0.04 in upwards to fix 40 cal chambering issues) -Magazine release moved 0.01 inch upward (done to help move magazine upwards) -Magazine well moved 0.02 inch rearwards (add clearance for angled mag release, assist in chambering) -Grip shortened 0.01 inch to account for higher magazine

BETA v0.01 -Initial Release For M&P Beta Testers